Artistic Wire® Teardrop Connector Jig
E94Z: : : Materials : : :
STEP 1
Place the end of wire (20-24 gauge) 6'' (15cm) in length across findings form as shown, tail should only be a few millimeters off the form. |
STEP 2
Wrap the wire (counterclockwise) around the single peg at the top, while holding the tale with your non-dominant hand, then on to the next peg. |
STEP 3
Continue to take a single revolution with the wire around each of the pegs (counterclockwise). Then cross between the top peg and the acrylic form, but do not wrap onto the peg. |
STEP 4
Use the included pusher tool to push the design all the way down to the surface of the finding form. |
STEP 5
Hold the center of the connector as shown and wrap the left wire around the other wire. |
STEP 6
Wrap the left wire a full revolution around the right wire. |
STEP 7
Hold the top ring with chain-nose pliers as shown and wrap the other wire around the intersection until the component is secure. |
STEP 8
Carefully cut each of the ends with a flush-cutter and tuck them in as much as possible with chain nose pliers. |
Have a question regarding this project? Email Customer Service.
Copyright Permissions
Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.