Artistic Wire® Open Ear Wire Jig

Courtesy of Beadalon®
E94T
STEP 1
Bending the Wire on the Findings Form Insert a piece of wire (20-24 gauge) 5 inches (12.7cm) in length through the hole in the findings form and bend the end (this helps to hold the wire firmly as you bend the wire around the pegs).
STEP 2
Bending Wire Around the Form Line up the wire with the acrylic guide, then go in between the peg and the oval form at the top of the findings form, pulling firmly on the wire as you bend it around the form.
STEP 3
Wrapping Wire Over the Form Wrap the wire over and down the acrylic form (clockwise) then down the side of the triangle acrylic form then out to the right.
STEP 4
Cutting Wire with Flush-Cutters Cut the end of the wire as shown (it’s advised to use a wire rounder on the end of the earwire to smooth out the sharp edges left by the flush-cutters).
STEP 5
Using Round-Nose Pliers to Create Loop Use the long leg of the earwire to customize your earwires, then make a loop for dangling designs.
STEP 6
Finished Earwire Examples Far left a spiral and ring was added. Near left a pearl was added with a ring.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.