Lattice Bracelet Design

Pattern provided by CJ David
7254
The Lattice Design is unique. It produces a balanced design, exactly the same on both sides. By using two needles working back and forth as seen in the illustrations, each side will be even; allowing for concentration on design.

Color Code:

(A) Transparent dark green

(B) Transparent gold

(C) Opaque green

(D) Matte yellow

Wax approximately 3 feet of thread.

Thread 2 needles, one at each end.
STEP 1
Begin with 2(A), 1(B), 2(A), 1(B), 4(A), 2(B).
STEP 2
Circle around to pick up the last single colored bead.

At this point, leave the end of one thread longer than the other so that further on, thread can be added at different places.
STEP 3
Add 3(B), pick up second single color.
STEP 4
Add 2(B). Leave this needle.
STEP 5
Pick up the second needle. Add 2(A), go through last bead on other thread.

From this point and throughout your work, pull beads together firmly from time to time.
STEP 6
Add 2(B), 1(C) and join a second row.
STEP 7
Add 1(C), 2(B) and join a second row.
STEP 8
Turning into the fourth row, add 2(A), 2(B). Join to a third row.
STEP 9
Add 1(C), 1(D), 1(C). Join to a third row.
STEP 10
Add 2(B). Leave this needle.
STEP 11
Pick up the first needle. Add 2(A). Go through the last bead on the other thread.
STEP 12
Repeat steps 6-11 until desired length.
STEP 13
Add 3(B).
STEP 14
Add 3(B).
STEP 15
Add 4(A).
STEP 16
Add 2(A).
STEP 17
Add 4(A).

Tighten thread and tie together into a square knot. To hide ends, work thread back through about 12 to 15 beads and cut ends carefully close to work. Route each thread through a different path following an already worked thread.

Have a question regarding this project? Email Customer Service.

Copyright Permissions

Permission to copy this instruction sheet is granted for non-commercial educational purposes only. All other reproduction requires written permission. Please email copyrightpermission@firemtn.com for more information.